Wall Faceplate - Kenable

This wallplate is designed for standard coaxial cables that terminate with F-Type connectors, such as those used for satellite and cable TV. Common cable types include RG6 and RG59.

Yes, this wallplate is designed to fit a standard single surface back box. You will need to have one already installed or install one before mounting the wallplate.

The wallplate features screw/clamp termination. You will need to strip the coaxial cable appropriately and then secure it by tightening the screws or clamps on the rear of the F-Type connectors.

If your internet service provider uses an F-Type connector for your modem or router, you can use one of the ports. However, the primary design is for satellite and cable TV signals.

You will likely need a screwdriver for the fixing screws and the termination screws/clamps, and a cable stripping tool to prepare the coaxial cable for connection.

This is a flushmount style plate designed to fit onto a surface back box, creating a neat finish on the wall surface.

Verify that the coaxial cables are correctly terminated on both ends. Ensure the center conductor is making good contact and the shielding is properly connected. Check that the correct F-Type plugs are used and securely fastened to the wallplate.

Inspect the cable terminations for any loose connections or damaged conductors. Ensure the coaxial cable is not kinked or excessively bent. Check for any damage to the cable itself or the connectors on the wallplate. Confirm the wallplate is installed on a suitable back box and is not causing strain on the cables.

Confirm that you are using a standard single surface back box. Ensure no obstructions are preventing the wallplate from seating correctly. If the back box is non-standard, alternative mounting solutions may be required.