Bond It Drive Alive Colour Enhancer - Red - 4L

This product is designed for direct application onto bare concrete and paving. Existing paints or sealants may affect adhesion and the final colour outcome. It's best to remove old coatings or test in a very small, inconspicuous area first.

Typically, one thin, even coat is sufficient. However, for a deeper colour or to ensure full coverage, a second thin coat can be applied once the first coat is touch dry. Avoid applying the product too thickly.

Coverage will vary depending on the porosity and texture of the surface. As a guide, a 4L tub can cover approximately 8-12 square meters for one coat on a typical concrete surface. Always refer to the product's specific instructions for detailed coverage estimates.

While the product is solvent-free and low odour, it is designed for outdoor use on exterior paving and concrete. Ensure good ventilation if used in an enclosed outdoor space like a garage.

The duration of the colour enhancement and protection depends on factors like traffic, weather exposure, and maintenance. The UV-stable formulation and protective barrier help to extend the lifespan of the colour compared to untreated surfaces.

No, the Bond It Drive Alive Colour Enhancer is a ready-to-use formulation and does not require diluting. Stir well before and during use.

Please refer to the packaging or Bond It's official website for the most current warranty information, as this can vary.

Ensure the product was thoroughly stirred before and during application. Avoid over-application and puddling. Apply in thin, even coats. If streaks persist, a second carefully applied coat might help, or consider a sacrificial test patch on a hidden area.

Drying times are dependent on temperature and humidity. Cold or humid conditions will significantly slow down the drying process. Ensure application is planned for dry, warmer weather if possible. Avoid applying just before rain.

A test patch on an inconspicuous area is crucial to confirm colour depth. Colours can appear different once dry compared to when wet. Always use tubs from the same batch for consistent colour across the entire project.

This can occur if applied too thickly or if there was insufficient airflow during drying. Try to ensure thin coats and good ventilation. If it persists after 24 hours, contact Bond It customer support.