DeWalt Power Tools Self-Feed Drill Bits - 32mm

This drill bit is ideal for wood, MDF, hardboard, and chipboard. It is not designed for use on metal or masonry.

It is compatible with most corded and cordless drills. However, for optimal performance and safety, a drill with variable speed and a clutch is recommended, especially for a bit of this size.

The aggressive spur at the tip of the bit is designed to pull the bit into the material with minimal user force, allowing for faster drilling.

Use a steady pressure and a moderate drill speed. Ensure the cutting edges are sharp. For materials prone to splintering, consider drilling halfway through from each side.

The non-slip shank is designed to provide a more secure grip in the drill chuck, reducing the chance of the bit spinning or slipping, especially under heavy load.

After use, clean off debris with a brush and store in a dry location. Periodically check the sharpness of the cutting edges and spur.

Ensure the drill is set to drill mode (not reverse). Check that the self-feed spur is sharp and not damaged. Apply steady, consistent pressure. Ensure the material being drilled is appropriate (wood, MDF, etc.).

Reduce drill speed. Ensure the cutting edges are sharp. For softer woods, consider drilling halfway through from one side, then finishing from the other to minimize tear-out.

Ensure the non-slip shank is clean and dry. Tighten the drill chuck more securely. Use a drill with a reliable chuck mechanism.

Use a drill with higher torque or a lower speed setting. Use the clutch setting on your drill if available to prevent damage to the drill motor or the bit.