Magnusson 225mm Ratcheting Wire Stripping Tool

The tool supports wires with cross-section areas of 0.75mm2, 1.0mm2, 1.5mm2, 2.5mm2, 4.0mm2, and 6.0mm2, with corresponding wire diameters of 0.8mm, 1.0mm, 1.3mm, 1.6mm, 2.0mm, and 2.6mm.

The wire size setting should match the size of the wire you're stripping. You can typically find this information printed on the wire insulation. If not, measure the wire diameter and consult the tool's markings.

Wipe the tool with a clean, dry cloth after each use. Remove any debris or insulation residue from the stripping slots.

Store the tool in a dry, safe place to prevent rust or damage. Consider using a tool bag or organizer.

Make sure you are using the correct setting, and that the wire is properly inserted. If the problem persists, the blades may need sharpening or replacement.

Please refer to the product packaging or your point of purchase for warranty information.

Ensure the correct wire size setting is selected. Check for any obstructions in the stripping slot. The blades may need to be replaced.

Check that the wire is correctly inserted into the stripping slot. Make sure the handles are fully squeezed to activate the mechanism.

Reduce the pressure applied, or ensure that you are using the correct setting for the wire being used. If the issue continues, contact customer service.