Duplex Rope Clip Clamp Fixing - 6 x 3 mm - SolaDirect

The U-bolt of the clamp should be placed over the loose end of the rope (the end you are looping back), and the saddle should be placed over the main, standing part of the rope. The nuts should be tightened on the U-bolt.

For most wire rope applications, a minimum of two duplex rope clips are recommended for secure termination. For critical loads, consult rigging best practices or a professional.

Yes, these clamps are also suitable for use with jute and polypropylene ropes, provided the clamp diameter matches the rope diameter.

This typically indicates the clamp is designed for a 6mm diameter wire rope, with the '3 mm' potentially referring to the diameter of the U-bolt or saddle material.

Tighten the nuts until the clamp is snug and holds the rope firmly. Avoid overtightening, which can deform the rope. It's recommended to re-tighten after the rope has been under initial load.

Its primary function is to create a secure loop, or eye, at the end of a rope by clamping the rope back onto itself. This loop can then be used for connecting to other hardware.

Ensure the clamp diameter precisely matches the rope diameter. Verify that at least two clamps are used and spaced correctly. Check that the U-bolt is on the free end and the saddle is on the standing part. Re-tighten nuts after initial loading.

The clamp size may be too small for the rope, or the nuts may be overtightened. Ensure the correct clamp size is used and tighten nuts gradually until snug, not excessively tight.

Clean the clamp with a wire brush. For steel clamps, apply a light protective lubricant. If corrosion is severe and compromises the clamp's integrity, replace the clamp.