Fascia Internal Corner Trim - 300mm Anthracite Grey Smooth

No, this product is specifically designed for internal 90-degree corners.

Yes, as a Freefoam product, it is manufactured to withstand standard outdoor UV exposure without significant fading.

The trim comes in a finished Anthracite Grey; painting is generally not recommended as it may void the warranty and lead to finish peeling.

No, a standard fine-toothed hand saw or a hacksaw is sufficient to achieve a clean cut.

The trim is rigid to maintain its shape, but can be slightly flexed to snap into position over tight corners.

Since this component is 300mm, it would not cover the full vertical depth of a board larger than 300mm; please verify your fascia measurements prior to purchase.

Check the fascia board alignment; ensure there is no protruding nail head or debris preventing the trim from sitting flat.

Use a hacksaw or a fine-toothed PVC saw to carefully trim the corner to the correct height required for your specific board width.

Ensure a high-quality, exterior-grade adhesive was used; apply additional sealant or adhesive if the bond has failed.