Rasch Realistic Marble Effect Metallic Wallpaper - Grey

Use a sharp utility knife or snap-off blade and a straight edge (like a metal ruler or spirit level) for clean, precise cuts. Cut carefully along the ceiling line, around electrical outlets, and at the skirting boards.

While it can be used in a kitchen, it is best suited for areas away from direct splashes or high humidity. For areas around sinks or cooktops, consider a more robust, washable material.

Each roll covers 10 square meters. Measure the total area of your walls in square meters (width x height) and divide by 10. Always round up to the nearest whole roll to account for pattern matching and potential waste.

It has a smooth finish that allows for gentle wiping with a slightly damp cloth. It is not considered fully washable in the way a vinyl wallpaper might be, so avoid harsh scrubbing or excessive water.

A good quality, solvent-free wallpaper adhesive suitable for non-woven or standard wallpapers is recommended. Always follow the adhesive manufacturer's instructions and the wallpaper manufacturer's guidelines.

Typically, non-woven wallpapers can be stripped dry from the wall. If it proves difficult, dampen with warm water and a little wallpaper adhesive remover, then scrape gently.

Ensure the wall was properly prepared and free of dust. Re-adhere loose edges with appropriate wallpaper paste. For significant bubbling, the section may need to be carefully removed, the wall re-prepared, and the paper re-applied.

Work in good lighting and take your time. If a slight misalignment occurs, gently reposition the strip before the paste sets. For future applications, ensure the starting strip is perfectly vertical.

This can sometimes occur due to the nature of metallic inks and light reflection. Ensure the wallpaper is applied smoothly without creases. The overall effect is designed to be subtle and may vary slightly with viewing angle.

Check that the correct type of wallpaper adhesive has been used and applied evenly to the wall. Ensure the wall surface is porous enough to accept the adhesive. Re-paste the affected area if necessary.