Actis Hybris Multifoil Insulation Panel - 125mm

The honeycomb structure creates numerous small, enclosed air cavities. These cavities are insulated from dust and air movement, significantly enhancing the product's thermal performance by reducing heat transfer through convection and conduction.

Actis Hybris is primarily designed for framed constructions (timber or masonry). For solid walls, it's typically used as part of a system, often with an associated air gap and framing, to create a thermal break and allow for insulation build-up. Consult specific system guidelines for solid wall applications.

The aluminum-coated polyethylene foils are highly reflective. When an air cavity is present next to the foil, it reflects radiant heat, reducing heat transfer. This property is most effective when combined with an air gap of at least 25mm.

This particular panel is 1145mm in width, 1200mm in length, and 125mm in thickness.

A vapor control layer is often recommended on the warm side of the insulation to prevent moisture vapor from reaching cold surfaces within the construction and condensing. The specific requirement depends on the overall wall, roof, or ceiling construction and the climate. Always consult building regulations and manufacturer guidance.

Actis Hybris is designed for internal applications within the building envelope (walls, roofs, ceilings). It is not intended for direct external exposure.

One panel measures 1.145m x 1.200m, covering approximately 1.374 square meters.

Ensure there are adequate air cavities adjacent to the insulation as recommended by the manufacturer. Check for any compression or damage to the panels. Verify that a vapor control layer has been correctly installed if required by the build-up.

Use a sharp, long-bladed utility knife or specialized insulation saw. Score the surface and cut through the material cleanly. Ensure a stable surface for cutting.

This indicates a potential issue with moisture ingress or inadequate ventilation. Ensure a continuous and properly sealed vapor control layer is installed on the warm side of the insulation. Check for any breaches in the building fabric.

Ensure the panels are cut to fit snugly and are adequately supported. Use appropriate mechanical fixings or battens to secure the insulation firmly within the framework. Do not rely solely on friction fit for long-term stability.