Best current price£32.95from eBay
Shopping.co.uk recommended and popular offers
eBay£32.95Visit shop HEIGHT LEVEL SENSOR FRONT RIGHT FOR VW PHAETON, TOUAREG 7LA, PORSCHE CAYENNE
Visit shop4 offers from £32.95 - £32.96
View price history by clicking the chart icon.
The D2P Suspension Ride Height Level Sensor (TA4E0941286G) is designed for vehicle owners and mechanics seeking a reliable replacement component to maintain precise suspension geometry and optimal ride quality. This sensor is specifically engineered for the front right side of select Audi, VW, and Porsche models, providing essential feedback to the vehicle's electronic leveling system. While it offers a direct-fit solution that mirrors OEM specifications, it is important to note that professional calibration is often required after installation to ensure the system accurately registers the new sensor's output.
| Model Part Number | TA4E0941286G |
|---|---|
| Brand | D2P |
No, this product typically includes the sensor unit itself; reuse your existing hardware or replace it if bolts are corroded.
Yes, calibration is highly recommended to ensure the suspension module correctly interprets the signals from the new sensor.
No, this sensor is specifically designed for the front right side and is not interchangeable with the left-side sensor.
You will need standard hand tools (sockets and wrenches) and an automotive diagnostic scan tool for the final reset procedure.
Common signs include a sagging vehicle corner, dashboard warning lights, or an air suspension fault code stored in the computer.
The new sensor must be calibrated using an OBD-II diagnostic tool to sync the sensor output with the control module.
Inspect the physical linkage arm connected to the sensor for signs of seizing or excessive play.
Verify the 4-pin D-shaped connector is fully seated and inspect the wiring harness for corrosion or pinched wires.
To install the D2P sensor, ensure the vehicle is safely raised and supported on jack stands. Locate the sensor on the front right suspension control arm, disconnect the 4-pin wiring harness, and remove the retaining bolts. Mount the new sensor in the exact orientation of the old unit, tighten the fasteners to manufacturer specifications, and reconnect the harness. Following physical installation, a scan tool is usually necessary to reset the suspension module's adaptation values. To ensure long service life, inspect the sensor linkage during routine oil changes to confirm there is no binding or physical damage caused by road salt or debris.
