Integral LED Evofire Mini Fire Rated Downlight - White - 55mm

The Integral LED Evofire Mini downlight typically requires a cutout diameter of approximately 45-50mm. It is always best to consult the product's specific installation instructions or template for precise measurements.

No, this downlight is a fixture and requires a compatible LED lamp to be purchased separately.

Yes, with its IP65 rating, it is protected against dust and water jets, making it perfectly safe and suitable for installation in bathrooms and other moisture-rich environments.

This downlight is certified for fire resistance for 30, 60, and 90 minutes, providing significant protection for your ceiling structure.

The ultra-thin 1mm bezel provides a very discreet and modern look, blending seamlessly into the ceiling surface with minimal visual impact.

Yes, the downlight is designed for easy lamp replacement. Simply remove the downlight from its housing (ensure power is off), access the lamp holder, and replace the bulb with a compatible LED.

The dimmability of the light depends entirely on the LED lamp you choose to install. Ensure you select a dimmable LED lamp and a compatible dimmer switch for your system.

Check that the power supply is switched on at the mains. Verify all wiring connections are secure and correctly made to the loop-in/loop-out terminal block. Ensure the compatible LED lamp is correctly seated and functional.

This is often related to the connected LED lamp. Try replacing the LED lamp with a known compatible and functional unit. Check wiring for loose connections.

Ensure the downlight is not being obstructed, allowing for proper heat dissipation. Confirm that the connected LED lamp is rated for use in enclosed fixtures and is not exceeding its recommended operating temperature. Verify the lamp is correctly installed.

While designed for heat dissipation, excessive heat may indicate an issue. Check that the connected LED lamp is suitable and not drawing too much power. Ensure there is adequate ventilation around the fitting in the ceiling void if possible, and that the patented open design is not blocked.