Proxxon Scroll Saw - 2 Speed

The saw accepts both standard saw blades with pin ends and regular fretsaw blades without pins.

The maximum cutting depth varies depending on the material. For wood, it's 50mm; for plastic, it's 30mm; and for non-ferrous metals, it's 10mm.

Yes, it has two speeds.

The table can be tilted up to 45 degrees for miter cuts.

Keep the saw clean by removing sawdust, and lubricate moving parts as needed. Check and replace blades if damaged.

It is suitable for wood, plastic, non-ferrous metals, Plexiglas, glass fiber reinforced plastic, foam, rubber, leather, and cork.

Replacement blades are available from Proxxon retailers and online.

Warranty information is not available in the provided product data.

Check blade tension; ensure it's properly adjusted. Use the correct blade type for the material. Reduce cutting speed if necessary.

Ensure the blade is perpendicular to the table. Check the blade tension. Guide the material slowly and steadily.

Reduce the cutting speed or the feed rate. Check if the material is too thick for the blade and saw. Ensure the saw is receiving proper voltage.

Ensure the saw is placed on a stable surface. Check and tighten all screws. Ensure the blade is properly installed and tensioned.