Autojack Multimeter - Autojack

Warranty information is not available in the provided product information. Please refer to the product packaging or retailer for warranty details.

Always disconnect power before testing circuits. Avoid contact with live wires. Wear appropriate safety gear.

Set the dial to the AC voltage (V~) setting and connect the probes to the circuit.

Set the dial to the DC current (A) setting. The circuit must be broken, and the multimeter connected in series with the circuit.

No, this multimeter is not designed for high-voltage applications. Doing so could result in damage to the device or injury to the user. Always check the specifications to ensure compatibility.

Set the multimeter to the continuity setting. Place the probes on either end of the fuse. If the fuse is good, the multimeter will beep. If not, the fuse is blown.

Check the batteries and replace if necessary. Ensure the batteries are installed correctly.

Ensure the probes are securely connected. Check the function dial is set to the correct measurement type. Replace the batteries.

The input signal exceeds the range of the selected function. Change to a higher range or function.

Check the probes and the circuit for proper contact. Ensure the circuit is complete.