Nilfisk Pressure Washer - 160 bar

Connect the water supply and turn on the water. Point the spray gun away from yourself and turn the pressure washer on to allow water to flow through the system.

The maximum input water temperature is 40°C. Do not use water hotter than this, as it may damage the pump.

Clean the inlet filter regularly, especially if you have hard water or a poor water supply. The filter is accessible and can be rinsed with water.

Use detergents specifically designed for pressure washers. Avoid harsh chemicals that could damage the pump.

Disconnect the water and power supply. Drain the water from the pump by running the pressure washer briefly after disconnecting the water. Store in a dry place.

Please refer to the warranty information that came with the product. Typically, Nilfisk products have a warranty period, but this can vary depending on the product and region.

Replacement parts and accessories are available through Nilfisk authorized dealers or directly from the Nilfisk website.

Check the power connection, ensure the outlet is working, and verify the power switch is turned on.

Check the water supply and ensure adequate water flow. Inspect the nozzle for blockages and clean or replace it if necessary.

Inspect all connections (hose, gun, and pump) and tighten them. Check for cracks or damage to the hose and replace if needed.

Check the water inlet filter for clogs. Make sure the hose is not kinked. Inspect the pump for airlocks and bleed if necessary.

Ensure the detergent tank is filled correctly. Make sure the detergent nozzle is properly attached and not blocked.