Polypipe MDPE Pipe - 50mm - 50mtr - Blue

This pipe is suitable for both potable (drinking) and non-potable cold water supply installations.

The pipe is rated for a maximum pressure of 12 bar, making it suitable for standard cold water mains applications.

No, this MDPE pipe is specifically designed and rated for cold water applications only.

This pipe is designed to be used with MDPE compression fittings that are compatible with 50mm diameter PE80 pipe.

Store the pipe away from direct sunlight, extreme temperatures, and sharp objects. Allowing it to relax in ambient temperatures can make installation easier.

The 50-meter coil length helps to reduce the number of joints required in an installation, which can save time, reduce potential leak points, and improve overall installation efficiency.

Yes, the blue colour coding is for rapid and clear identification as a water service pipe, distinguishing it from other utility lines.

Ensure the pipe is fully inserted into the fitting and the nut is tightened correctly. Check the fitting and pipe end for damage or debris. Verify the fitting is compatible with 50mm MDPE pipe.

Allow the pipe to warm up to ambient temperature before attempting to bend it. Use a pipe uncoiler or lay it out in the sun briefly to reduce coil memory. Avoid sharp bends; use appropriate radius bends if needed.

Check for blockages within the pipe or at connection points. Ensure the pipe is not compromised or collapsed. Verify the water supply pressure is adequate.

While the pipe is blue for identification, some slight fading over extended periods in direct UV light is possible. Ensure the integrity and material composition remain unchanged. If significant degradation is suspected, consult the manufacturer.