Diall Fine Iron Plasterboard Screw - Black
Best current price£8.94from B&Q
Best offers
Shopping.co.uk recommended and popular offers
B&Q£8.94Visit shop B&Q - Phillips Bugle Carbon Steel Plasterboard Screw (Dia)4.2mm (L)80mmPack Of 200
Visit shopB&Q£8.94Visit shop One Offer
1 offer from £8.94
View price history by clicking the chart icon.
B&QB&Q - Phillips Bugle Carbon Steel Plasterboard Screw (Dia)4.2mm (L)80mmPack Of 200
Free delivery in 1–3 days
£8.94
Visit shop
Product Information
Full details
This guide is for DIY enthusiasts and professionals using Diall Fine Iron Plasterboard Screws in black. These screws offer a reliable fastening solution for plasterboard, providing a secure hold for a range of projects. Note that these screws are specifically designed for use with steel and plasterboard applications.
All features
| Colour | Black |
|---|---|
| Brand | Diall |
Extended Product Information
FAQs
What size drill bit should I use for pre-drilling?
If pre-drilling is necessary, use a drill bit slightly smaller than the diameter of the screw. A 3mm drill bit is usually appropriate.
Are these screws suitable for outdoor use?
These screws are intended for interior use and may not be suitable for outdoor applications due to potential corrosion. Consider using screws specifically designed for outdoor environments.
What is the recommended spacing for the screws?
Spacing depends on the application, but a general guideline is to space the screws approximately 6-8 inches apart along studs and joists. Refer to local building codes for specific requirements.
Can I use these screws with wood studs?
These screws are specifically designed and recommended for use with steel. Using them with wood may not provide the same level of performance and hold.
What is the purpose of the black phosphate coating?
The black phosphate coating provides corrosion resistance, helping to prevent rust and extend the life of the screws.
How do I ensure a flush finish?
Use a screw gun with a depth-limiting nosepiece. This will stop the screw at the correct depth, ensuring a flush finish. Avoid over-tightening.
What type of screwdriver bit do I need?
Use a Phillips head bit, as these screws have a Phillips head design.
Troubleshooting
Screw head is stripping during installation.
Reduce the driving speed of the screw gun or use a screw gun with a lower torque setting. Ensure the correct drill bit is used if pre-drilling.
Screw is not holding securely.
Ensure the screw is fully inserted into the steel stud. If the stud is too hard, consider pre-drilling a pilot hole.
Screw head is protruding from the plasterboard surface.
Adjust the depth setting on the screw gun to ensure the screw head sits flush with the surface.
Pros and Cons
Pros
- Durable carbon steel construction ensures long-lasting performance.
- Black phosphate coating provides corrosion resistance.
- Countersunk head allows for a flush, professional finish.
- Partially threaded design offers a strong grip in plasterboard.
- Suitable for a wide range of DIY projects.
Cons
- Specifically designed for plasterboard and steel, limiting use with other materials.
- The black finish may be visible after installation.
- May require pre-drilling depending on the type of steel used.
Setup, Compatibility & Care
- Preparation: Ensure the plasterboard is properly aligned with the steel studs.
- Installation: Use a screw gun with a depth-limiting nosepiece to drive the screws. The countersunk head should sit flush with the plasterboard surface.
- Compatibility: These screws are specifically designed for use with plasterboard and are recommended for steel.
- Care: Avoid over-tightening the screws, as this can damage the plasterboard. If the screw head breaks the surface of the plasterboard, back the screw out and re-install in a new location.