Best current price£4.52from Power Tools Direct
Shopping.co.uk recommended and popular offers
Power Tools Direct£4.52Visit shop Trend Snappy Flat Bit 10Mm Pk 1 Snap/Fb/10
Visit shop
Amazon£4.75Visit shop Trend 10mm Flat Bit With Centre Point & Spurs For Fast Timber Drilling | Ideal For Quick, Clean Holes In Timber With Centre Point And Cutting Spurs For Accurate Starts, SNAP/FB/10
Visit shop25 offers from £4.52 - £10.07
View price history by clicking the chart icon.
The Trend Snappy 12mm Flat Bit is an essential tool for woodworkers and DIY enthusiasts looking to drill clean, accurate holes in timber with speed and precision. Its primary benefit lies in its integration with the Trend Snappy Quick Release system, which significantly reduces tool changeover time; however, users should note that as a flat bit, it is specifically optimized for timber and may not be suitable for metal or masonry drilling tasks.
| Model Part Number | SNAP/FB/12 |
|---|---|
| Brand | Trend |
Yes, the 1/4 inch hex shank will fit in most standard three-jaw drill chucks, though it is designed primarily for quick-release systems.
No, this bit is strictly designed for timber applications. Using it on metal will destroy the cutting edges immediately.
Place a sacrificial block of wood behind the target timber or drill until the tip emerges and finish the hole from the other side.
The drilling depth is limited by the length of the flat paddle section; for deep holes, ensure you clear the shavings frequently to prevent overheating.
Yes, it uses a standard 1/4 inch (6.35mm) hex shank, making it compatible with almost all quick-change bit holders.
Ensure the center point is sharp and use a punch to create a small pilot dimple in the wood before starting the drill.
Drill at a higher speed, or use a piece of scrap wood clamped tightly behind the workpiece to support the fibers as the bit exits.
Verify that the hex shank is fully seated in the quick-release chuck and that the chuck itself is not worn or loose.
To install, simply pull back the collar of your Trend Snappy Quick Release chuck and insert the 1/4 inch hex shank until it clicks into place. Ensure the bit is fully seated before initiating rotation. Compatibility is universal across standard 1/4 inch hex bit holders, though it is optimized for the Trend Snappy range. After use, inspect the cutting edges for wood debris. Clean the bit with a dry brush or compressed air to remove resin buildup. If the cutting edges dull over time, they can be lightly sharpened with a fine file, though care must be taken to maintain the original geometry of the back-tapered edge. Always store in a dry location to prevent surface corrosion.
