Anaglypta Wallpaper Adhesive - 10 Rolls Pack

The amount of adhesive needed depends on the wallpaper type. Refer to the mixing ratios provided for guidance. One sachet typically covers between 2 and 10 rolls, depending on the wallpaper.

This adhesive is suitable for most wallpaper types. However, always check the wallpaper manufacturer's instructions for specific recommendations. Adding PVA is recommended for heavyweight papers.

Drying time can vary depending on environmental conditions (temperature, humidity), and the type of wallpaper. However, it typically takes 24 to 48 hours for the wallpaper to completely dry.

Soak the wallpaper with warm water and allow it to penetrate. Use a scraper to gently remove the wallpaper.

Unopened adhesive should be stored in a cool, dry place and has a shelf life of approximately two years from the date of manufacture.

If the adhesive is too thick, add a small amount of water and mix thoroughly until the desired consistency is achieved. Be careful not to add too much water.

Ensure the surface is clean, dry, and properly prepared. Add PVA if using heavyweight wallpaper. Make sure the adhesive is mixed correctly and applied evenly.

Use a wallpaper smoother to remove air bubbles. Ensure the wall is smooth before application. Use the correct amount of adhesive for the wallpaper type.

Ensure the wall is dry before applying the wallpaper. The adhesive contains a mould inhibitor but proper ventilation is also important. Address any existing mould issues before application.