Laser Tools Mini Air Needle De-Scaler - 9218

Its primary purpose is to remove rust, scale, paint, and weld spatter, particularly in hard-to-reach areas due to its compact and lightweight design.

The tool should be oiled daily, typically by adding a few drops of pneumatic tool oil into the air inlet before each use.

The recommended working pressure is 90 PSI.

While powerful for its size, it is designed primarily for precision work in confined spaces. For very large-scale or heavy-duty surface preparation, a larger tool might be more appropriate.

Always wear eye and ear protection. Ensure the safety trigger lever is engaged when not actively using the tool to prevent accidental activation.

The tool consumes approximately 1.7 CFM (Cubic Feet per Minute) of air.

It weighs 587g, has a length of 236mm, and a diameter of 28.5mm.

Ensure the tool has been oiled daily. Check air pressure is set to 90 PSI and that the air supply is adequate (1.7 CFM minimum). Inspect air line for kinks or leaks.

This may indicate a blockage or internal issue. Ensure daily oiling. If the problem persists, the tool may require servicing.

Check all connections, particularly the air inlet fitting. If the leak is from the main body, internal seals may need attention or replacement.

Ensure needles are properly seated and not damaged. Check that the tool is being oiled correctly. Wear appropriate hearing protection as the standard operating noise level is 86dB.