Best current price£11.95from eBay
Shopping.co.uk recommended and popular offers
eBay£11.95Visit shop Spray Gun Whirlwind In-Line Air Filter - Spraygun Oil and Water Trap From Bitec
Visit shop2 offers from £11.95 - £12.74
View price history by clicking the chart icon.
The Starchem Whirlwind In-Line Air Filter is designed for professional mechanics, automotive painters, and DIY enthusiasts who rely on pneumatic tools. By effectively trapping moisture, oil, and particulates directly at the tool connection, it prevents damage and ensures consistent performance. While this filter is an essential safeguard for extending the life of your equipment, it requires regular monitoring to ensure the accumulated contaminants do not impede airflow during extended heavy-duty tasks.
| Colour | Black |
|---|---|
| Model Part Number | GUNFILTER |
| Brand | Starchem |
Replacement frequency depends on air quality and usage intensity. Replace it as soon as you notice visible debris or moisture accumulation inside the filter housing.
The filter is designed for standard workshop pneumatic pressures. Ensure your air system does not exceed the maximum pressure rating of your specific pneumatic tools.
It captures the majority of aerosolized moisture and oil, but it should be considered a secondary filter used in addition to a primary compressor tank dryer or separator.
No, the internal filtration element is sealed within the housing. Once saturated or dirty, the entire unit should be disposed of and replaced.
Under normal operating conditions, the filter is designed to maintain sufficient CFM for standard tools. If you notice a power loss, it is likely time to replace the filter.
The filter media may be clogged. Inspect the filter and replace it with the second unit in the pack to verify if the flow restriction is the cause.
Ensure the fittings are tightened properly and verify that you have used compatible thread sealant or tape on the pipe threads.
This suggests the filter is fully saturated. Remove and replace it immediately, and check your primary compressor tank for excessive water buildup.
Installation is straightforward: simply disconnect your tool from the air hose, screw the Whirlwind filter onto the tool inlet, and attach your air hose fitting to the other side of the filter. Ensure all threads are seated correctly and use thread sealant if necessary to prevent air leaks.
Compatibility is broad, fitting standard 1/4" NPT fittings typically found on most shop air tools. To care for the unit, visually inspect the clear housing before every session. If you see water or oil buildup, replace the unit. While the filter is designed for durability, do not submerge it in solvents to clean it, as this can degrade the internal filtration media.
