Setup, Compatibility & Care
Compatibility
This product is specifically designed for:
- AiM SmartyCam HD
- AiM SmartyCam GP HD
- AiM SmartyCam 3 GP
- AiM Corsa series
Setup Steps
- Ensure the vehicle power is switched off before beginning installation.
- Connect the 12V power leads to a switched ignition source on the vehicle.
- Route the 2-meter cable through the chassis, securing it with zip ties to avoid interference with pedals or steering.
- Position the microphone in a location shielded from direct wind but close to the engine bay or cabin noise source.
- If using an intercom, plug the radio system lead into the 3.5mm female jack.
Care Instructions
Regularly inspect the cable for signs of abrasion or wear, especially where it passes through firewall or dashboard grommets. Keep the 3.5mm connection clean and free of dust, and avoid pulling on the cable to disconnect, as this may strain the internal wires.