OKODOKO Carbon Brushes - CB325

The replacement frequency depends on usage. For heavy daily use, inspect every few months. For occasional use, check annually. Replace them when they are worn down to about 1cm or show signs of significant wear.

The OKODOKO CB325 carbon brushes are specifically designed and tested for compatibility with the listed OKODOKO tool models. Using them in other brands or models not on the compatibility list is not recommended and may cause damage or safety issues.

Worn carbon brushes can lead to reduced tool performance, increased sparking, overheating of the motor, and potential damage to the tool's commutator, which is more expensive to repair or replace.

Yes, the CB325 is an OKODOKO branded part designed as a replacement for their specified power tool models.

Typically, only basic tools like a screwdriver may be needed to remove the brush holder covers, depending on your specific tool model. Always refer to your tool's manual for specific instructions.

MPN stands for Manufacturer Part Number. CB325 is the specific identifier for this carbon brush model from OKODOKO.

The carbon brushes are likely worn out and need replacement. Ensure the new brushes are correctly installed.

Worn carbon brushes can cause poor electrical contact. Replace the brushes with new OKODOKO CB325 units and check for proper seating.

Double-check that you have the correct brush model (CB325) for your specific OKODOKO tool model. Ensure no debris is obstructing the brush holder.

Verify that the tool is properly connected to a power source. Ensure the brushes are correctly installed and making good contact with the commutator. If issues persist, consult the tool's main manual.