Best current price£27.95from eBay
Shopping.co.uk recommended and popular offers
eBay£27.95Visit shop TREND 3/83DCX1/2TC Worktop Cutter Two Flute Cutter 12.7mm Diameter x 50mm 1/2...
Visit shop7 offers from £27.95 - £58.95
View price history by clicking the chart icon.
The Trend Pro TCT Router Cutter is an essential tool for professional woodworkers and DIY enthusiasts who require high-performance routing in abrasive materials such as chipboard, MDF, plywood, and hardwoods. Designed with a 1/2-inch shank and tungsten carbide tips, this cutter delivers a superior finish and long-lasting durability; however, users should note that the large 50mm cut length requires multiple passes on deeper materials to prevent burning or motor strain.
| Model Part Number | 3/83DCX1/2TC |
|---|---|
| Brand | Trend |
No, this router cutter has a 1/2-inch shank and will not fit in a 1/4-inch router collet.
No, this tool is specifically designed for wood, MDF, plywood, and plastics. Using it on metal will cause immediate damage to the carbide tips.
The cutter has a specific cutting length of 50mm.
Frequency depends on usage, but you should notice a decline in edge quality or an increase in required feed pressure when the edges become dull.
While the plunge tip allows for starting cuts in the middle of a board, freehand routing should only be performed by experienced users with proper templates or guides.
Heat is usually caused by taking too deep of a cut or feeding the wood too slowly. Try taking shallower passes and maintaining a consistent feed rate.
Reduce the depth of cut per pass or increase the feed rate slightly to allow the flutes to clear chips more effectively.
Check that the collet is tightened properly and that the bit is fully seated. Ensure the router speed is adjusted for the diameter of the cutter.
Soak the cutter in a resin solvent or wood-bit cleaner and gently scrub with a nylon brush; avoid using metal scrapers that could damage the carbide edge.
To ensure safe operation, always insert the 1/2-inch shank into your router collet at least 3/4 of the way up the shank, but never past the indicator line. Ensure the collet is clean and free of resin before tightening.
Compatibility: This cutter is designed for routers equipped with a 1/2-inch collet capacity. It is compatible with both fixed-base and plunge routers, though plunge routers are recommended to fully utilize the center tip functionality.
Care: Clean the bit regularly using a specialized resin cleaner to remove sawdust and sap. If the cutter becomes dull, avoid DIY sharpening as it can affect the precision grind of the carbide; consult a professional sharpening service or replace the bit to maintain finish quality. Store in a protective case to prevent edge damage when not in use.
