Bath / Shower Seal - EUROSHOWERS

This seal is specifically designed for shower screens and bath panels with 6mm thick glass.

The seal is capable of effectively sealing gaps between the glass and the shower tray or bath edge that are up to 8mm wide.

The seal comes in a standard length of 1 meter (100cm). It can be cut to size if a shorter length is required.

No, installation is typically tool-free. The seal is designed to push onto the glass edge. You may need scissors or a utility knife if you need to cut it to size.

Clean the seal regularly with a soft cloth and mild soapy water. Avoid using abrasive cleaners or solvents.

This seal is generally designed for straight edges. Its suitability for curved glass depends on the radius of the curve and the flexibility of the seal. It is best suited for straight applications.

The seal will still function, but it may not compress as much. Ensure a good contact is still made to prevent leaks. If the gap is very small, a thinner seal might be more appropriate.

Ensure the glass edge is clean and dry. Try slightly warming the seal with a hairdryer on a low setting to make it more pliable. Double-check that the glass thickness is exactly 6mm and the seal's channel is designed for this.

Verify that the gap being sealed is not larger than 8mm. Ensure the seal is fully seated on the glass and making firm contact with the tray/bath. Check for any debris trapped under the seal. Consider if the shower screen or bath panel is uneven.

Re-clean the glass edge thoroughly. Ensure the seal was pushed on completely and securely. If the seal material appears deformed, it may need to be replaced.

Use a sharp craft knife or heavy-duty scissors to carefully trim the seal to the required length. Ensure the cut edge is clean and straight.