Kenable Cat6A Sstp Snagless Shielded Rj45 Network Ethernet Cable 6M White

Cat6A (Category 6A) supports higher frequencies (500MHz) and is designed for 10 Gigabit Ethernet up to 100 meters, often featuring better shielding and construction to handle increased data rates and reduce crosstalk compared to standard Cat6.

SSTP stands for Screened Shielded Twisted Pair. It indicates that each pair of wires within the cable is individually shielded, and the entire cable bundle may also be shielded, offering maximum protection against electromagnetic interference (EMI).

Snagless boots with a wing design, like on this cable, protect the RJ45 clip from breaking when the cable is pulled or snagged. They offer a balance of protection and accessibility to the clip.

This cable is designed for indoor use in environments with high EMI. It is not rated for outdoor or direct burial, which requires cables with specific weatherproofing.

Alien crosstalk is unwanted signal interference between adjacent cables, especially noticeable at higher frequencies and speeds. SSTP Cat6A cables are designed to minimize this.

For optimal performance in high EMI environments, it is recommended to use shielded connectors, patch panels, and network devices that support the shielding. However, the cable will still function in unshielded setups, providing enhanced protection over unshielded cables.

Ensure both ends of the cable are securely plugged into the correct ports. Try a different port on your router or switch. Test with another known working cable to rule out a cable fault.

Verify that the cable is connected to Cat6A or higher rated ports on both devices. Check network device settings to ensure they are configured for the highest possible speed. Ensure the cable is not damaged or excessively kinked.

Check for physical damage to the cable or connectors. Ensure the snagless clip is intact. If the cable is in a high EMI area, ensure all shielding is properly terminated at both ends (e.g., using shielded connectors and patch panels).