Ryobi Cordless Drain Auger - 18V ONE+

The Ryobi Cordless Drain Auger can feed its cable down pipes up to 50mm (approximately 2 inches) in diameter and is effective for clearing blockages within these pipes.

Yes, this product is sold as a 'bare tool', meaning the Ryobi 18V ONE+ battery and charger are not included and must be purchased separately if you do not already own them.

Run time varies depending on usage and battery capacity. With a 5Ah Ryobi 18V ONE+ battery, the tool can run for over 3 hours on a single charge.

The drain auger is equipped with a 6.8-meter (approximately 22 feet) reinforced cable.

While it can be used for various domestic drains, its 6.8m cable length and 50mm pipe diameter suitability suggest it's primarily intended for indoor plumbing like sinks, toilets, and baths, rather than deep sewer lines.

After use, retract and clean the cable thoroughly. Ensure the drum is drained using the rear port and store the tool in a dry environment. Inspect the cable and head regularly for wear.

Warranty information is typically provided by the retailer or Ryobi directly. Please refer to your product documentation or the Ryobi website for specific warranty terms.

Check that the battery is properly seated and charged. Ensure there are no kinks or severe blockages in the cable itself that are preventing movement. Clean any debris from the feed mechanism.

Ensure the auger head is the appropriate size for the blockage. Try rotating the cable in both directions (if applicable) and apply steady forward pressure. For very stubborn clogs, a chemical drain cleaner might be needed in conjunction or as a first step.

Ensure the rear drain port is clear and functioning correctly. After use, open the drain port to allow all water to escape. Check the drum for any cracks or damage.

Verify that the battery is charged and correctly inserted into the tool. Check the battery contacts for dirt or damage. Try a different Ryobi 18V ONE+ battery if available.