Best current price£8.62from B&Q
Shopping.co.uk recommended and popular offers
B&Q£8.62Visit shop B&Q - 6 Pack 50mm Steel Wire Cup Brush For Drills Brass Coated Rust Paint Remover
Visit shop2 offers from £8.62 - £10.82
View price history by clicking the chart icon.
This 6-pack of AB Tools 50mm steel wire cup brushes is designed for professionals and DIYers needing to clean, deburr, and blend edges on various materials. Its primary benefit is offering controlled abrasion to remove rust and paint without damaging underlying surfaces, unlike more aggressive twist wire brushes. A key consideration is the 4500 RPM maximum speed, requiring users to operate within this limit for safety and effectiveness.
| Brand | AB Tools |
|---|
The maximum recommended speed is 4500 RPM. Always operate below this speed to ensure safety and tool longevity.
Yes, they can be used on wood for tasks like distressing or cleaning, but use light pressure and lower speeds to avoid damaging the material.
No, these are not twist wire brushes. They are designed for more controlled abrasion, removing less material for a gentler cleaning effect.
They are compatible with most standard electric, battery-powered, or air drills that accept a 6mm (1/4") shank.
After use, clean debris from the bristles with a stiff brush or compressed air. Store them in a dry environment.
The galvanized steel construction, particularly in the cup and wheel housings, provides enhanced durability and resistance to corrosion, extending the life of the brush.
Each brush has a cup width of 50mm, a wire bristle depth of 15mm, and a 6mm shaft length of 25mm.
Ensure the drill speed is appropriate and you are applying consistent, moderate pressure. Check if the bristles are worn or damaged; if so, replace the brush.
Verify the brush is securely seated in the drill chuck. Ensure the brush is not bent or damaged. Check that the drill itself is functioning correctly.
You may be applying too much pressure or exceeding the recommended speed. Reduce pressure and ensure you are operating below 4500 RPM. Check for hardened material build-up on the bristles.
Setup: Securely insert the 6mm (1/4") shank of the wire cup brush into the chuck of your electric, battery, or air-powered drill. Ensure the chuck is tightened firmly to prevent slippage during operation. Always start the drill at a low speed and gradually increase if necessary, ensuring you do not exceed the maximum speed of 4500 RPM.
Compatibility: These brushes are designed to fit into the chucks of standard drills with 6mm or 1/4" collets. Verify your drill’s specifications if unsure.
Care: After use, clean any debris from the bristles using a stiff brush or compressed air. Store the brushes in a dry place to prevent rust. Periodically inspect the bristles and housing for wear or damage. If significant bristle loss, bending, or housing damage is observed, the brush should be replaced.
