Araldite Crystal Tubes Epoxy Adhesive - 2 x 15ml

The working time, or pot life, for this adhesive is approximately 5 minutes once the resin and hardener have been mixed.

The adhesive will reach its full strength in 2 hours. While it sets within minutes, allow the full 2 hours for optimal bond performance.

The product description specifies bonding metals, ceramics, wood, and glass. While many epoxies work on some plastics, for specific plastic types, it's always best to test on an inconspicuous area first or consult product data sheets if available, as some plastics are difficult to bond.

The product is water-resistant, but it is not specifically rated as food-safe. It is generally not recommended for direct or prolonged contact with food or drinking water surfaces.

Uncured adhesive can be cleaned up immediately using a solvent like acetone (nail polish remover) or methylated spirits. Once cured, the adhesive is very difficult to remove and typically requires mechanical means (scraping, sanding).

While it provides a strong and durable bond, specific high-temperature resistance data is not provided. For applications involving extreme heat, consider consulting product specifications for temperature limits.

Yes, the product boasts eco-friendly packaging designed for easy recycling, aligning with its environmentally friendly formulation.

Ensure you mixed equal parts of the resin and hardener thoroughly for at least 30 seconds. Inconsistent mixing or incorrect ratios are the most common causes. Also, ensure the ambient temperature is not too cold, as this can slow down curing; ideally, apply at room temperature.

Ensure surfaces were completely clean and dry before application. Excessive air bubbles introduced during over-mixing can also cause cloudiness. Always use the correct 1:1 ratio and mix just enough to combine properly.

Proper surface preparation is crucial. Ensure surfaces were clean, dry, and slightly abraded if very smooth. Also, make sure the parts were held or clamped firmly together during the initial setting time to allow for good adhesion.

Ensure the caps are removed and the nozzles are clear. If the adhesive has partially cured in the nozzle, clear it with a pin. For easier dispensing, store at room temperature, as cold temperatures can make the components thicker.