Neilsen Angle Grinder - 900W 4.5" 115mm

This angle grinder is compatible with 4.5" (115mm) discs with an M14 spindle thread. Ensure the disc is rated for a speed of at least 12,000 RPM.

Use the spindle lock button to hold the spindle. Unscrew the disc retaining nut, remove the old disc, insert the new one, and tighten the retaining nut securely.

Always wear safety glasses, gloves, and a dust mask or respirator. Ensure the workpiece is securely clamped. Keep bystanders away from the work area. Never use a damaged disc.

The Neilsen Angle Grinder comes with a 1-year warranty against manufacturing defects.

Yes, you can use this grinder for polishing with the appropriate polishing pad and compound. Ensure you use the correct speed and pressure for the polishing task.

If the grinder overheats, stop using it immediately and allow it to cool down. Check for any blockages around the vents. Avoid continuous operation for extended periods.

Wipe the grinder with a dry cloth after each use to remove dust and debris. Do not use liquids to clean the motor housing. Avoid getting water inside the grinder.

Check the power supply and ensure the power cord is securely plugged into a working outlet. Check the power switch and ensure it is in the 'on' position. Inspect the power cord for any damage. If the issue persists, consult a qualified technician.

Ensure the disc is properly secured and not damaged or unbalanced. Tighten the disc and check for any debris causing imbalance. Consider replacing the disc if the vibration continues.

Ensure you are using the correct disc type for the material. Apply appropriate pressure, but avoid forcing the cut. Check the disc for wear and tear; replace it if necessary.

Ensure the disc is not jammed. Clean around the spindle lock mechanism to remove any debris. Apply a small amount of lubricant. If the problem persists, the spindle lock may need servicing.