Immersion Heater Spanner - Cranked Type - Todays Tools

The cranked handle provides extra clearance, allowing you to access and work on immersion heater elements that are located in tight spaces, recessed, or surrounded by insulation without damaging them.

The jaw size is precisely 86mm, designed to fit the hex head of specific immersion heater elements.

No, this spanner is specifically designed for immersion heater elements with an 86mm head. It is not a general-purpose tool.

Make sure the spanner is fully engaged onto the hex head of the immersion heater element. The design of the jaws is intended to provide a firm grip on standard element heads.

It is manufactured from high-quality steel for durability and strength.

No, it is designed for immersion heater elements with an 86mm jaw size requirement. Always measure your element's hex head before purchasing.

Ensure the spanner jaw is fully seated and centered on the hex head of the element. Clean any debris from both the element head and the spanner jaws. If the element head is damaged or worn, it may require replacement.

Check if there is sufficient clearance for the cranked portion of the handle. The design is specific for recessed or insulated elements; if the element is easily accessible, a standard spanner might be more appropriate. Ensure you are not trying to use it in a situation where the offset is not needed.

Inspect the spanner for any obstructions or damage. Ensure it is properly aligned with the immersion heater element. If the element is seized, additional penetrating oil may be required (follow manufacturer instructions for the water system).