Q.Max Sheet Metal Punch - 11mm

The Q.Max Sheet Metal Punch - 11mm requires a 5mm hexagonal wrench (key) to operate.

This punch is specifically designed for sheet metal up to 16 gauge. Using it on other materials may damage the tool or yield poor results.

Yes, the Q.Max punches are sold individually, and the hexagonal key must also be ordered separately. For smaller sizes (up to 15mm), a die and die nut are typically required and may be sold separately or as a set depending on the specific offering.

The specialized design of the Q.Max punch naturally creates a burr-free hole. Ensure the punch and die are correctly aligned and that the cutting edges are clean for optimal performance.

This punch is designed to cut clean holes in sheet metal up to 16 gauge thickness.

No, the instructions provided apply to cutters up to 15mm in size. For cutters 15mm and over, the configuration is different, often featuring fewer components, and the thread may be directly in the punch without a separate die nut.

After use, clean the punch and die. Apply a light coat of oil to the cutting edges and threads periodically, especially during storage, and keep the tool in a dry environment.

Ensure the sheet metal is within the 16 gauge limit. Check that the punch and die are properly aligned and that the hexagonal screw is being turned with sufficient force using the correct wrench.

Verify that the die nut is touching the metal surface and that the punch is correctly threaded onto the screw. Ensure the hexagonal wrench is fully seated in the screw head. Lubricate the screw threads if necessary.

This can happen if the metal is too thick or if there is excessive burring. Try backing off the die nut slightly and re-engaging the punch. Ensure the cutting edges are clean and free from debris.

Wipe the tool dry and apply a light oil to the metal surfaces, especially the cutting edges and threads, to prevent further corrosion. Store in a dry environment.