FloPlast Half Round Gutter Internal Stopend - 112mm Brown

An internal stopend is used inside a gutter fitting, such as a running outlet, to seal off the end of the gutter run at that fitting, preventing water from escaping where it's not intended.

No, this is an *internal* stopend. It must be installed within another fitting. For directly capping the end of a gutter run, you need an *external* gutter end cap.

This stopend is specifically for 112mm FloPlast Half Round gutter systems.

No, this internal stopend relies on the rubber seal already present within the gutter fitting it is installed into.

It is inserted into the appropriate port of a gutter fitting, with the back edge going in first, and then gently compressed onto the fitting's rubber seal.

This specific product is brown.

This listing is for a pack of one internal stopend.

Ensure you are using the correct size (112mm) and profile (Half Round) for your gutter system. Check that the fitting's rubber seal is properly seated and not damaged. Verify you are inserting it into the correct port of the fitting.

The stopend may not be fully compressed onto the fitting's seal. Remove and reinsert, ensuring firm pressure is applied to seat it completely. Inspect the fitting's seal for damage and replace if necessary.

Ensure the fitting opening and the stopend are clean and free of debris. Lubricating the rubber seal slightly with water can sometimes help with insertion, but avoid excessive force.