Mexco TDXCEL Diamond Tile Hole Saw 91mm

The hole saw is compatible with angle grinders with M14 threads. It can also be used with mains-powered drills using the M14 Chuck Adaptor (sold separately).

While it can be used on some hard materials, performance may vary on granite. Always test on a scrap piece first.

The lifespan depends on the material being drilled, usage frequency, and pressure applied. The wax core helps extend the life.

No, this hole saw is designed for dry drilling, so no water is required.

The wax core melts during drilling, providing lubrication and cooling to the cutting surface.

Drilling speed should be adjusted based on the tile material's hardness. Start with a moderate speed and increase or decrease as needed.

If you're using a mains-powered drill, you'll need the M14 Chuck Adaptor. Attach the hole saw to the adaptor, then secure the adaptor into your drill's chuck.

Ensure sufficient pressure is applied. Check the tile material's hardness and adjust drilling speed if necessary. Check if the wax core is melting. If not, increase drilling speed or pressure slightly.

Reduce pressure and allow the wax to lubricate the cutting surface. If the problem persists, try using a slightly slower drill speed.

Reduce pressure and allow the wax to cool the saw. Ensure the saw is not being forced, and check the drill speed.