DAB JetInox 132 M Garden Pump - DAB Control-D

If your model has a priming port, fill the pump with water through this port. Alternatively, ensure the suction hose is submerged in the water source to allow the pump to draw water.

The DAB Control-D provides dry-run protection, shutting the pump off. Check the water source and address the lack of water before restarting the pump.

The filter should be cleaned regularly, especially if you are pumping water from a source that may contain debris. Check the filter every few weeks and clean it as needed.

While the pump provides pressure, it is not specifically designed for use with pressure washers. Using it for this purpose may not provide the desired pressure levels. Check the specific requirements of the pressure washer.

Please refer to the product documentation or contact your supplier for warranty details.

Replacement parts are available from authorized DAB dealers or online retailers specializing in pump components. Contact DAB customer support to determine correct replacement parts.

In winter, drain all water from the pump and store it in a dry, protected location to prevent freezing and potential damage.

Check the power supply and ensure the pump is properly connected. Verify the Control-D system is functioning correctly and that there is sufficient water at the source.

Check for air leaks in the suction hose. Prime the pump if necessary. Inspect the impeller for blockages and clear any obstructions.

Check for leaks in the discharge piping system. Adjust the pressure settings on the Control-D if applicable.

Check for any blockage in the hoses or the pump itself. Inspect the water source to ensure it is adequate.