FloPlast Access Plug - 32mm

An access plug, often called a cleaning eye, provides a sealed point of entry into a waste pipe system. It allows for inspection and cleaning of the pipes if blockages occur, preventing the need to dismantle large sections of the plumbing.

Solvent weld is a method of joining plastic pipes and fittings (like ABS) where a solvent cement is applied to both surfaces. The solvent temporarily dissolves the plastic, allowing the surfaces to fuse together as the solvent evaporates, creating a strong, permanent, and watertight bond.

No, solvent weld joints are permanent and cannot be demounted once the joint has been made and cured. If you need to change the configuration, the connected pipe and fitting will need to be cut out and replaced.

The numbers refer to the diameter of the pipe the fitting is designed to connect to. A 32mm plug is for 32mm diameter pipe, a 40mm plug is for 40mm pipe, and a 50mm plug is for 50mm pipe. You must choose the plug that matches your waste pipe's outer diameter.

Yes, the FloPlast ABS Solvent Weld Access Plug features a UV-stable finish, making it resistant to degradation from sunlight and suitable for outdoor applications where it may be exposed to the elements.

This solvent weld waste fitting is manufactured in the UK to BS EN 1455 standards and is Kitemarked, ensuring it meets rigorous quality and safety requirements.

You will need a pipe cutter to ensure a clean, square cut on the pipe, SC250 solvent cement, and a cloth for cleaning. Ensure you are working in a well-ventilated area when using the solvent cement.

This usually indicates an improper solvent weld. The joint may not have been made correctly (e.g., insufficient twist, improper solvent application) or was disturbed before fully curing. Leaks from solvent weld joints often require cutting out the faulty section and re-installing. Ensure pipes and fittings are clean and dry, and solvent cement is applied correctly during the next attempt.

Ensure both the pipe end and the fitting socket are clean and free of obstructions. If the pipe is slightly deformed, try to gently square it off. Ensure you are using the correct size fitting for the pipe. Applying a small amount of SC250 solvent cement to both surfaces can also help lubricate the joint for easier assembly.

Check the temperature of the working environment; solvent cements perform best within a specific temperature range (typically above 5°C). Ensure the correct type of solvent cement (SC250 recommended for ABS) is being used and that it has not expired. If the joint was made in very humid conditions, this could also affect curing.