Osma RoundLine Gutter Jointing Bracket - 112mm Black

The primary function is to connect two ends of the Osma RoundLine 112mm gutter sections.

This bracket is specifically designed for the Osma RoundLine 112mm gutter system with a 68mm downpipe.

The bracket features expansion markings that assist in allowing for thermal expansion.

You will need a screwdriver or drill for fixing the bracket to the fascia board, and potentially a measuring tape and level.

No, this bracket is designed for the Osma RoundLine 112mm gutter system and may not be compatible with other systems.

Regularly inspect and clean the guttering system, removing any debris. Use warm, soapy water and avoid harsh chemicals.

Check the joint for proper alignment and ensure the gutter sections are fully inserted. If necessary, use sealant designed for gutter systems.

Ensure that the gutter sections are properly inserted into the bracket and that the fascia board is level. Check for any obstructions.

Check the joint for any gaps or misalignments. Ensure the gutter sections are fully inserted and that the bracket is correctly installed. Sealant may be required for older systems.

Check and tighten the fixings securing the bracket to the fascia board. Ensure that the correct screws were used and are not stripped.