T-Mech Wet Tile Cutter Bench - 920mm - 1200W

The T-Mech Wet Tile Cutter Bench can handle a variety of tiles, including ceramic, porcelain, and stone.

The maximum tile length the cutter can handle is 920mm.

The head of the cutter tilts up to 45 degrees in either direction for angle and mitre cuts.

Check and adjust the laser guide. Ensure the tile is properly aligned before cutting. Inspect the blade for damage or wear.

Yes, a water supply is required for wet cutting to reduce dust and keep the blade cool.

Clean the machine after each use, regularly check the water reservoir, and inspect/replace the blade when necessary. Store the machine in a dry place when not in use.

Always wear eye protection and other appropriate safety gear when operating the machine.

Check the power connection and ensure the outlet is working. Verify the power switch is in the 'on' position.

Check and adjust the laser guide. Ensure the tile is properly aligned before cutting. Inspect the blade for damage or wear.

Ensure the blade is appropriate for the tile type. Check for blade damage. Increase the water flow to the cutting area.

Ensure the machine is placed on a stable surface. Check the blade for proper mounting and balance. Tighten any loose parts.