Best current price£9.44from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£9.44Visit shop (Tee) Ip68 Waterproof Cable Connector Electric Wiring Junction Box Outdoor 5061098943384
Visit shop
B&Q£9.90Visit shop B&Q - Ip68 Waterproof Cable Connector Electric Wiring Junction Box Outdoor Tee
Visit shop3 offers from £9.44 - £9.90
View price history by clicking the chart icon.
The GTV IP68 Waterproof Cable Connector in a tee configuration is designed for professionals and DIY enthusiasts who need to secure outdoor wiring against environmental hazards. It provides a robust, weather-resistant junction that prevents moisture and dust ingress, ensuring long-term electrical reliability. While it offers superior protection, users should note that proper tightening of the cable glands is mandatory to maintain the integrity of the IP68 seal.
| Brand | GTV |
|---|
IP68 means the connector is dust-tight and protected against the effects of continuous immersion in water under conditions defined by the manufacturer.
While the connector is waterproof, it is designed for exterior above-ground or surface-mounted use; verify local electrical codes regarding burial of connectors.
Please consult the packaging for the specific cable diameter range, as the integrity of the IP68 seal depends on the cable size fitting the gland correctly.
No special tools are required; the design is intended for manual tightening, though a standard screwdriver may be needed for internal wire terminations.
The connector uses UV-stabilized materials designed to resist brittle cracking and color fading from prolonged sun exposure.
Verify that the compression nut is tightened sufficiently and check that the internal rubber gasket is seated correctly without being pinched.
Ensure the cable diameter is within the manufacturer's recommended range for the gland; if the cable is too thin, the seal will not grip.
Check the threads for debris or grit; clean them gently and ensure the cap is aligned perfectly before turning to avoid cross-threading.
To install, first slide the compression nut and rubber washer onto your cable. Strip the outer insulation of the cable to expose the inner wires, then connect them to the internal terminal block inside the tee housing. Once connected, tighten the compression nuts firmly by hand until the rubber seal is compressed against the cable jacket.
Compatibility note: Ensure your cable diameter matches the specification of the gland. Avoid overtightening with pliers, as this can crack the plastic threads. For maintenance, periodically inspect the connectors after extreme weather events to ensure that the casing is still intact and that the compression nuts have not vibrated loose.
