Bartoline Direct to Rust Multi-Surface Paint - Black - 400mL

No, this product is designed to act as a primer, undercoat, and topcoat all in one. It can be applied directly to rusted metal surfaces.

The paint is suitable for use on metal (including rusted metal), wood, plastic, and ceramic surfaces.

The paint should be applied in temperatures between 15°C and 25°C for best results.

Yes, it is suitable for both interior and exterior jobs, but it must be applied in a well-ventilated area or outdoors due to its formulation.

Allow 15-20 minutes between thin coats. The paint will take approximately 24 hours to fully harden.

After each use, invert the can and spray for 2-5 seconds to clear any paint from the nozzle and prevent blockages.

Use a stiff brush or steel wool to remove loose corrosion and other surface contaminants before applying the paint.

Shake the aerosol can more frequently during use. Ensure the nozzle is clear by performing the post-use clearing step. Try increasing the distance from the surface slightly.

Ensure the surface is clean, dry, and free from grease or oil. For metal, make sure all loose rust and contaminants have been removed with a brush or steel wool before application.

Apply thinner coats. Reduce the distance from the surface or slow down the spray motion. Allow adequate drying time between coats.

The nozzle may be blocked. Invert the can and spray for 2-5 seconds to clear it. If still blocked, a replacement nozzle might be required or try soaking the nozzle in a suitable solvent (check manufacturer advice).