Unibond Seal & Bond Sealant Cartridge - White

The joint width must be designed to suit the movement capability of the sealant. In general, the joint width must be greater than 10 mm and less than 35 mm.

Yes, the product contains a fungicide for sealing joints in warm, humid environments where there is a likelihood of mould growing, making it suitable for bathrooms and kitchens.

The sealant will be touch dry in approximately 30 minutes. Full cure times can vary depending on temperature, humidity, and joint depth, but typically takes 24-48 hours for full strength.

Yes, items can be adjusted after application. However, for heavy items or those under tension, support them until the adhesive is fully cured.

It bonds to most common building materials including wood, metal, glass, ceramics, concrete, and some plastics. Always test on a small area first if unsure.

'Touch dry' means the surface will not transfer wet product to a lightly touching finger. It does not mean the product is fully cured or has reached maximum strength.

No, the application instructions state it is not valid for Foldable Gun DW111/120.

Ensure the nozzle tip has been cut and that the cartridge is correctly loaded into the sealant gun and the gun's trigger mechanism is engaged properly.

Verify that surfaces were clean, dry, and free from contaminants before application. Ensure the joint width is within the recommended 10-35mm range for sealant applications.

While the product contains a fungicide, persistent mould issues may indicate underlying moisture problems that need to be addressed. Ensure adequate ventilation in the area.

Practice with the sealant gun on a scrap piece of material. Ensure consistent pressure and speed during application. Tool the bead immediately after application for a smooth finish.