Setup, Compatibility & Care
Setup:
- Ensure your walls are clean, dry, and free from imperfections. Prepare the wall surface if necessary.
- Cut the wallpaper to the required length, allowing for a slight overlap at the ceiling and skirting board.
- Apply wallpaper adhesive directly to the wall, covering an area slightly wider than the wallpaper width.
- Hang the wallpaper strip, aligning the edges with the previous strip or starting point.
- Smooth the wallpaper against the wall using a wallpaper brush or roller, working from the center outwards to remove air bubbles.
- Trim any excess wallpaper at the ceiling and skirting board using a sharp craft knife.
Compatibility:
This wallpaper is suitable for most interior walls, including plaster, previously painted surfaces (ensure paint is sound), and lining paper. It is not recommended for use in areas of extreme humidity or direct water contact. Always ensure the wall surface is properly prepared and primed if necessary.
Care:
The vinyl surface can be cleaned gently with a damp cloth or sponge. For tougher marks, use a mild soap solution, but avoid abrasive cleaners that could damage the matte finish. Pat the area dry after cleaning.