Sekonic Litemaster Pro L-478DR-EL - Elinchrom

It uses two AAA alkaline batteries (1.5V).

No, the integrated Skyport control and power adjustment features are specifically designed for Elinchrom flashes equipped with the EL-Skyport protocol. It can measure light from any flash system when used as a standard light meter.

No, the 5-degree spot viewfinder is an optional accessory and must be purchased separately.

The Sekonic L-478DR-EL can operate in temperatures ranging from -10°C to 50°C.

Connect the meter to your camera's sync port with a sync cord, or use it wirelessly if your flash system supports it. Set the meter to flash mode and trigger the flash. The meter will display the exposure information.

The cine settings allow you to input your desired frame rate and shutter angle. The meter then provides exposure readings optimized for motion picture standards, ensuring correct exposure and motion blur.

Use a soft, dry, lint-free cloth. For tougher smudges, slightly dampen the cloth with water and wipe gently, then dry immediately.

Ensure two fresh AAA alkaline batteries are correctly installed in the battery compartment. Check that the power button is being pressed correctly.

Verify that the Elinchrom flashes have the EL-Skyport protocol enabled and are within radio range. Ensure the meter's Skyport settings are correctly configured and paired with the flashes.

Ensure the meter is set to the correct mode (ambient, flash, incident, reflected). Clean the incident dome and check for any obstructions. For flash metering, ensure the sync cord or wireless trigger is functioning correctly.

Try turning the meter off and on again. Ensure the screen is clean and dry. If issues persist, contact customer support.