Best current price£16.84from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£16.84Visit shop 4-Wing Spoilboard Surfacing Router Bit 1/4 Inch T Type Slotting Router Bit Durable Carbide Tipped Wood Milling Cutter Woodworking Tools 6926684806452
Visit shop1 offer from £16.84
View price history by clicking the chart icon.
The KTouler 4-wing T-type slotting router bit is designed for woodworkers, cabinet makers, and CNC operators who need high-precision flattening and grooving. This bit provides exceptional stability and clean, burn-free cuts across various wood types, though it requires careful feed rate management due to its wide 1-19/32 inch cutting diameter.
| Brand | KTouler |
|---|
Yes, it is compatible with hand-held portable routers as long as the collet supports a 1/4 inch shank.
The cutting depth is 1/4 inch; do not attempt to cut deeper in a single pass.
No, this bit is designed specifically for wood and wood-based composite materials only.
Due to the precise geometry of the carbide inserts, it is recommended to have them professionally sharpened to maintain balance.
Yes, it is highly effective for CNC surfacing and spoil board flattening tasks.
Reduce the feed rate or increase the router speed to ensure the blades are cutting rather than rubbing.
Check that the bit is fully seated and the collet is tightened properly; also verify that the workpiece is securely clamped.
Check the alignment of your router base or CNC spindle to ensure it is perfectly perpendicular to the material surface.
To install, ensure your router collet is clean and free of debris. Insert the 1/4 inch shank fully into the collet, then pull it back out approximately 1/8 inch before tightening to prevent the bit from 'bottoming out,' which can cause vibration. Regularly inspect the carbide teeth for resin buildup; clean these with a dedicated resin remover to maintain cutting efficiency. Store the bit in its original packaging or a protective case to prevent edge chipping. Always verify that your machine's speed settings are appropriate for the diameter of the bit before initiating a cut.
