CCA Carpet Joining Tape - Gel Double Sided

The fiberglass reinforcement and robust gel adhesive are designed for long-term durability, comparable to professionally installed seams, assuming proper application.

While the tape has strong adhesive, it is designed to bond effectively with carpet underlay for optimal strength. Bonding directly to a hard floor may yield less permanent results and is not the intended use.

Use sharp scissors to cut the tape cleanly to the required length. Measure twice and cut once to ensure minimal waste and a perfect fit.

Once applied, the tape is securely bonded and poses no hazard. However, keep the roll and freshly applied tape away from pets and children to prevent accidental ingestion or adhesion to skin/fur.

The tape is 90mm wide, providing a substantial bonding surface for carpet seams and rug applications.

The gel adhesive is very strong. While minor adjustments might be possible immediately after application, it is best to aim for precise placement on the first attempt as repositioning can be difficult and may weaken the bond.

Ensure the carpet and underlay surfaces are clean, dry, and free from dust or debris. Press down firmly along the entire length of the seam.

Peel back the tape and reposition carefully. The gel adhesive may allow for minor adjustments if done quickly before significant pressure is applied.

Ensure you are peeling from the designated backing layer. Use a fingernail or a thin, flat tool to lift the edge if necessary.

Due to the strong adhesion, removal may damage delicate surfaces. Carefully try to lift an edge and proceed with caution. It's best to apply with precision to avoid this.