Everbuild One Strike Ready Mixed Filler 1L - White

You can use it on plaster, stone, brick, wood, and render. It is important that these surfaces are non-metallic and non-plastic.

Everbuild One Strike Filler is designed to fill holes up to 75mm deep in a single application.

You can typically paint or paper over the filler in just 30 minutes, though very deep fills or high humidity might slightly extend this.

Yes, it is waterproof and suitable for both indoor and outdoor applications.

The unique formula minimizes the need for sanding. For most applications, no sanding is required, but a light sand may be desired for a perfectly smooth finish.

Yes, Everbuild One Strike Filler can be overpainted or stained with most solvent-based or emulsion paints.

The filler dries to a brilliant white color.

This particular variant is a 1-liter tub of Everbuild One Strike Ready Mixed Filler.

Ensure adequate ventilation in the area and that the ambient temperature is suitable (e.g., above 5°C). Very deep fills or high humidity can slightly extend drying times. Apply in thinner layers if possible for extremely deep voids.

Verify the surface was clean, dry, and free from dust or loose debris before application. For very porous surfaces, a light misting of water or a suitable primer may sometimes improve adhesion (refer to specific paint/primer instructions if using).

Although minimal sanding is required, for a perfectly flush finish, light sanding with fine-grit sandpaper (e.g., 180-220 grit) may be necessary once fully dry. Ensure even application with a filler knife to minimize ridges.