Best current price£36.99from Robert Dyas
Shopping.co.uk recommended and popular offers
Robert Dyas£36.99Visit shop HexGuard - Wallsupply Polymer Grab Adhesive - 290ml - Black
Visit shop3 offers from £36.99 - £39.00
View price history by clicking the chart icon.
The Wallsupply Polymer Grab Adhesive is designed for DIY enthusiasts and interior professionals looking to securely mount 3D wall panels, particularly the Rebel of Styles range. Its primary benefit is a high-strength, moisture-resistant bond that works across diverse surfaces including masonry, wood, and PVC, though users should note that drying times can vary based on ambient humidity and surface porosity.
| Colour | Black |
|---|---|
| Model Part Number | 45110002-3 |
| Brand | Wallsupply |
Yes, provided the paint is stable and not peeling. It is recommended to sand glossy paint to improve adhesion.
Since one cartridge covers approximately 1.5 to 2 square meters, you will need 3 to 4 cartridges for a 5 square meter project.
It is moisture-resistant, making it suitable for standard indoor environments, though it is not intended for direct, prolonged submersion in water.
It is designed for wall panels; for ceiling applications, ensure you use adequate temporary support until the glue has fully cured.
While it has a quick initial grab, a full cure typically takes 24-48 hours depending on the temperature and humidity.
Ensure the nozzle tip is cut at a 45-degree angle and check that the internal foil seal has been fully punctured.
You may have applied too much adhesive or the substrate is non-porous; use temporary painter's tape to hold the panels in place until the initial set occurs.
Remove all dust and loose debris from the wall with a stiff brush or vacuum before re-applying the adhesive.
To begin installation, ensure you have a standard caulking gun to dispense the adhesive from the 290ml cartridges. Prepare your wall surface by removing any loose paint, wallpaper, or grease to ensure a clean bonding area. For best results, apply the adhesive in vertical beads. If the adhesive contacts your skin or tools, clean it immediately with a damp cloth before it cures. Store unused cartridges in a cool, dry place and ensure the nozzle is sealed tightly to prevent the polymer from hardening inside the tube.
