Best current price£0.37from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£0.37Visit shop Classicbond Epdm Seam Fastening Plates - 50Mm
Visit shop2 offers from £0.37
View price history by clicking the chart icon.
The ClassicBond EPDM 50mm Seam Fastening Plates (MPN 300600) are essential components for professional roofers and experienced contractors requiring a secure mechanical attachment for EPDM roofing systems. Designed specifically to clamp RUSS (Reinforced Universal Securement Strip) membranes, these plates provide high-strength reinforcement for horizontal and vertical transitions, though they require precise placement and compatible hardware to ensure long-term system integrity.
| Model Part Number | 300600 |
|---|---|
| Brand | ClassicBond EPDM |
These plates are specifically engineered for the ClassicBond system. Using them with other manufacturers' membranes may void your system warranty.
You must use fasteners compatible with your specific roof deck (timber, concrete, or metal) as specified in the ClassicBond technical guide.
The spacing of the plates is determined by the wind uplift requirements of your specific project location and height. Always consult the official project specification.
No. Once a fastening plate has been mechanically driven into a substrate, it should not be removed and reused, as the structural integrity of the fastener hole may be compromised.
No, the plates themselves do not require priming, but ensure the RUSS membrane surface they are clamping is cleaned and prepared according to the EPDM installation instructions.
The pilot hole is likely too large or the substrate is degraded; move the plate slightly to a fresh fastening position and use appropriate screws for the specific deck type.
Ensure that the RUSS membrane is pulled taut before securing the plate; if bubbles persist, check that the plate is flush against the surface without debris trapped underneath.
To ensure proper installation, always verify the substrate type (timber, concrete, or steel) and select the corresponding compatible fasteners. Never substitute with generic washers, as the 50mm plate is calibrated for specific load distribution. Once installed, ensure the plates are covered by the subsequent layer of EPDM cover strip or flashing as per the standard ClassicBond installation manual. Periodic inspection of the roof edge details should be performed during routine maintenance to ensure no fasteners have backed out over many years of heavy thermal cycling.
Timco Metal Insulation Discs - Silver - 70mmFrom £13
Screw Cup - Forgefix - BronzeFrom £6
Monument Autocut Copper Pipe Cutter Spare Wheel - Monument - 269NFrom £4
Toolpak Tungsten Carbide Grinding Disc 115mm x 22mmFrom £15
Forgefix Penny Washer - M8 x 25mm - WhiteFrom £1
Ideal Standard Dual Flush Valve Seal and Clip - SV01967From £4ForgeFix Flat Penny Washer - Silver - M6 x 25mmFrom £1
Mexco General Purpose Concrete Flush Cut Diamond Blade - 125mmFrom £59
Hemline Round Plastic Buttons - WhiteFrom £2
Forgefix Drywall Screws Wafer Head Self-Drill 4.2 x 13mm - WhiteFrom £8
LEE Filters 43mm Wide Angle Adaptor Ring - LEE FiltersFrom £40
Sanding and Polishing Plate - DeWalt - DT3611-QZFrom £12