FloPlast Equal Tee - 20mm

This product listing specifies a '20mm water pipe fittings mdpe 20mm 20mm mdpe tee', implying compatibility with standard MDPE pipe. Specific connection methods (like compression or push-fit) depend on the exact variant and should be confirmed. Always refer to the product packaging or detailed specifications for precise installation.

FloPlast MDPE fittings are typically designed for underground use and comply with relevant water regulations for potable water supply. Always confirm the specific product's suitability for your intended installation environment.

The pressure rating would depend on the specific variant and the type of MDPE pipe used. Generally, fittings for potable water systems are designed to handle standard domestic water pressures. For precise details, consult the manufacturer's technical data sheet.

Ensure the MDPE pipe is correctly prepared (clean, straight cut, no damage) and fully inserted into the fitting. For compression fittings, tighten the collar according to the manufacturer's instructions. For push-fit, ensure a firm push until it clicks or seats.

'Equal Tee' means all three connection points on the fitting are the same size. In this case, all three ports are for 20mm MDPE pipe.

No, this fitting is specifically designed for 20mm MDPE (Medium Density Polyethylene) water pipes. Using it with other pipe materials may result in leaks and system failure.

Ensure the MDPE pipe is fully inserted and seated. If it's a compression fitting, tighten the collar further. Check the pipe for damage or deformation. Re-seat the pipe and fitting.

Ensure the pipe end is cut squarely and is free of burrs. Slightly chamfering the pipe end can help. Ensure you are using the correct size pipe for the 20mm fitting.

Verify that the fitting is the correct type for the pipe (e.g., compression vs. push-fit) and that the pipe material is compatible MDPE. Check for any debris inside the fitting or on the pipe end.