Best current price£132.00from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£132.00Visit shop (32Mm 25M Coil, Red) Pre-Insulated Multilayers Composite Pex Al Pex Pipe 5060706095378
Visit shop2 offers from £132.00
View price history by clicking the chart icon.
The Wärmer System Pre-Insulated PEX-AL-PEX pipe is designed for professional installers and DIY homeowners looking for an efficient solution for hydronic heating, cooling, and potable water distribution. Its primary benefit is a multilayer composite design that offers the durability of an aluminum core with the flexibility of PEX, wrapped in factory-applied insulation to minimize thermal energy loss. While highly durable and energy-efficient, users should note that the integrated insulation increases the outer diameter of the pipe, which may require specific sizing adjustments when planning pathways through tight spaces or structural framing.
| Colour | Red |
|---|---|
| Model Part Number | PSWPALPEX-32025R |
| Brand | Wärmer System |
Yes, this PEX-AL-PEX pipe is suitable for potable water systems, provided your local building codes allow for multilayer composite piping.
While red is traditionally used to denote hot water lines for identification, the pipe material is capable of handling both hot and cold water temperatures.
Consult your local plumbing codes regarding direct burial. While the material is durable, specific burial depths and protection standards usually apply.
The minimum bend radius is generally 5 times the outer diameter of the pipe, but please refer to the specific technical datasheet for the exact radius based on the pipe size.
Use plastic pipe clips or hangers that are sized for the outer diameter of the insulated pipe to ensure you do not compress the insulation.
No, you must use fittings specifically rated for PEX-AL-PEX multilayer pipe to ensure a proper seal and structural integrity.
If the kink is minor, the aluminum core may be straightened, but if the outer layer is torn or the core is severely deformed, the section must be cut out and replaced with a coupling.
Ensure the pipe end was properly reamed/chamfered and that the fitting is fully seated; verify that the compression nut is tightened to the manufacturer's specified torque.
Check if the pipe end is perfectly round. Use a calibration tool to restore the round shape of the pipe after cutting.
Proper installation begins with ensuring you have the correct tools for the specific fitting system recommended by the manufacturer. Use a pipe cutter designed for multilayer pipes to achieve a square, burr-free end, which is critical for a watertight seal.
