Best current price£4.37from Bradfords
Shopping.co.uk recommended and popular offers
Bradfords£4.37Visit shop Plasson 7930 Mdpe Reducing Set 25Mm X 20Mm
Visit shop
Amazon£8.25Visit shop PLASSON 25mm x 20mm Reducing Set - 7930
Visit shop
eBay£8.42Visit shop Plasson Reducing Set 25mm x 20mm 7930 (PL079300025020)
Visit shop50 offers from £4.37 - £28.63
View price history by clicking the chart icon.
The Plasson Reducing Set is designed for professional plumbers and DIY enthusiasts needing to transition pipe sizes within MDPE water systems. This WRAS-approved component offers the key benefit of allowing standard compression fittings to adapt to smaller Metric PE pipe sizes, enhancing system flexibility without requiring specialized tools. Please note that this kit is specific to 50mm to 25mm reductions, so ensure your pipe measurements are accurate before installation to avoid leaks.
| Model Part Number | 1328075 |
|---|---|
| Brand | Plasson |
Yes, this product is WRAS approved, meaning it meets the requirements for use in potable water supply systems.
No, this is a mechanical compression set that can be installed using standard hand tools.
No, this reducing set is specifically designed for MDPE (Medium Density Polyethylene) water pipes.
This set reduces from a 50mm pipe fitting down to accommodate a 25mm pipe.
While the components are durable, it is best practice to inspect the O-rings for wear and replace them if they appear damaged or deformed before reusing the fitting.
Ensure the pipe is cut squarely and fully inserted past the O-ring. Tighten the compression nut further.
Check for burrs on the pipe end and ensure the pipe is clean and free of debris.
To install, ensure the pipe end is cut square and deburred to prevent damage to the fitting seals. Slide the compression nut and the necessary components of the reducing set onto the 25mm pipe. Insert the pipe firmly into the 50mm fitting body until it reaches the stop point. Tighten the nut by hand until it is firm, then use a wrench to provide the final tightening as specified by the fitting manufacturer. For care, avoid using abrasive cleaners or petroleum-based lubricants on the rubber seals, as these can degrade the material over time. Regularly inspect joints for signs of moisture if the system has been subjected to ground movement.
