DELIXI Tin Snips - DN12DHG

These snips are designed for cutting standard sheet metal. They are most effective on softer metals like aluminum, copper, and mild steel within their specified gauge limits.

While they can make gentle curves, these snips are optimized for straight cuts. For tight curves or circles, specialized aviation snips are recommended.

Sharpening frequency depends on usage. For frequent use, inspect blades monthly. For lighter use, inspect every few months. Listen for signs of dullness like ragged cuts.

Refer to the product specifications for the exact gauge limit. Typically, tin snips are best for lighter gauge sheet metals, usually up to 20-24 gauge depending on the metal type.

No, these tin snips are specifically designed for cutting sheet metal and are not intended for cutting wire, which can damage the blades.

Periodically clean any debris from the pivot area and apply a small amount of lubricating oil. Ensure the pivot screw is not too tight or too loose.

Check the pivot screw. If it's too tight, loosen it slightly. If it's too loose, tighten it. Ensure the blades are clean and free of debris.

Ensure the blades are sharp and properly aligned. Clean the blades thoroughly. Avoid forcing the snips; make steady, even strokes. If blades are dull, consider professional sharpening or replacement.

Wipe blades thoroughly with a dry cloth. Apply a light coat of lubricating oil to the blades and pivot. Store in a dry environment.